Great job on connectivity editing! It's a plasure to be able to define connectivity and test it at once in the same session.
I added connectivity to a few parts that missed it, zip file attached (is it the best way to share such information?).
One thing mildly bothers me: when you press insert to duplicate a snap meta, the new copy doesn't inherit it's parent parameters (this also annoys me for flex part control points)
Some notes on the parts I edited:
- arms of the 2717 Technic seat are not wide enough, that's why the connectivity cylinders poke inside.
- The Technic Chain Tread 38 connect easily together, but if I cap the bar part at both ends to limit sliding, I get no connectivity at all...?
- Speaking of sliding, what would you suggest to make these parts slide properly http://www.ldraw.org/cgi-bin/ptdetail.cg.../18942.dat http://www.ldraw.org/cgi-bin/ptdetail.cg.../18940.dat?
I added connectivity to a few parts that missed it, zip file attached (is it the best way to share such information?).
One thing mildly bothers me: when you press insert to duplicate a snap meta, the new copy doesn't inherit it's parent parameters (this also annoys me for flex part control points)
Some notes on the parts I edited:
- arms of the 2717 Technic seat are not wide enough, that's why the connectivity cylinders poke inside.
- The Technic Chain Tread 38 connect easily together, but if I cap the bar part at both ends to limit sliding, I get no connectivity at all...?
- Speaking of sliding, what would you suggest to make these parts slide properly http://www.ldraw.org/cgi-bin/ptdetail.cg.../18942.dat http://www.ldraw.org/cgi-bin/ptdetail.cg.../18940.dat?