After some initial stuff done with the LPub3D I noticed the following:
- It crashed once when I tried to add a divider, but in retrospective I think I was too impatient as the 3D View was still being rendered before the pop-up menu was shown. If I wait for the 3D view to update this issue did no occur anymore.
- When I choose to annotate all the parts in the BOM, my BOM Layout changes. If there are no annotations I could not resize the BOM anymore.
Regarding the ROTSTEP preview:
- I would really like to have the same view in the 3D mode as I see it at the current step. The standard render looks to be at 23.5°/45°. I did not find a way to get the same view in the document and in the 3D preview. I could not save the camera position. The different views make it difficult to judge.
- Having the "handles" to rotate it is a good way
- When updating the LPUB doc, I think a "I am working" Icon would not be bad, especially for larger models.
Thanks!
- It crashed once when I tried to add a divider, but in retrospective I think I was too impatient as the 3D View was still being rendered before the pop-up menu was shown. If I wait for the 3D view to update this issue did no occur anymore.
- When I choose to annotate all the parts in the BOM, my BOM Layout changes. If there are no annotations I could not resize the BOM anymore.
Regarding the ROTSTEP preview:
- I would really like to have the same view in the 3D mode as I see it at the current step. The standard render looks to be at 23.5°/45°. I did not find a way to get the same view in the document and in the 3D preview. I could not save the camera position. The different views make it difficult to judge.
- Having the "handles" to rotate it is a good way
- When updating the LPUB doc, I think a "I am working" Icon would not be bad, especially for larger models.
Thanks!