Hello,
I downloaded the last version, unzipped the SW, started it and added the paths. But I cannot get a render of the steps. I get the complete model but not the single steps. And I cenot find the generated PDF...
I used the attached LDR.
In the GUI, I can see the steps etc, but no PLI and CSI of the individual steps.
However, I can see the part lists (BOM) rendered at the end of the file, so the renderer option must work.
Gerald
I downloaded the last version, unzipped the SW, started it and added the paths. But I cannot get a render of the steps. I get the complete model but not the single steps. And I cenot find the generated PDF...
I used the attached LDR.
In the GUI, I can see the steps etc, but no PLI and CSI of the individual steps.
However, I can see the part lists (BOM) rendered at the end of the file, so the renderer option must work.
Gerald