Hi all.
Part 3678b.dat "Slope Brick 65 2 x 2 x 2 with Centre Tube" uses wrong "tube" on bottom.
Tube using "stud2a.dat" but its size is wrong (should be "stud4a.dat"?). Checked on Bricklink, LDD and LDraw editor (no check in real part, I don't have one).
Attached screenshot file shows 3678b (right, with green selection box) and 3003 (left) to compare underside tubes.
Mario
Part 3678b.dat "Slope Brick 65 2 x 2 x 2 with Centre Tube" uses wrong "tube" on bottom.
Tube using "stud2a.dat" but its size is wrong (should be "stud4a.dat"?). Checked on Bricklink, LDD and LDraw editor (no check in real part, I don't have one).
Attached screenshot file shows 3678b (right, with green selection box) and 3003 (left) to compare underside tubes.
Mario