I don't think you can really replace whole clips with primitives (there's so many different designs...). IMHO the best thing you can do is to replace the inner cylinder and edge with cyli/edge primitives, align them visually with MLcad (See example attached). Then rebuild the clip tip around primitive.
General Grievous( need help)
« Next Oldest | Next Newest »
| Messages In This Thread |
|
General Grievous( need help) - by Stan Isachenko - 2011-11-02, 15:09
Re: General Grievous( need help) - by Stan Isachenko - 2011-11-02, 15:10
Re: General Grievous( need help) - by Stan Isachenko - 2011-11-18, 20:46
Re: General Grievous( need help) - by Reuben Pearse - 2011-11-20, 22:15
Re: General Grievous( need help) - by Philippe Hurbain - 2011-11-22, 16:10
Re: General Grievous( need help) - by Stan Isachenko - 2011-11-21, 6:06
RE: General Grievous( need help) - by Reuben Pearse - 2021-04-28, 6:18
RE: General Grievous( need help) - by Philippe Hurbain - 2021-04-28, 15:37
RE: General Grievous( need help) - by Magnus Forsberg - 2021-09-06, 22:19
RE: General Grievous - by Magnus Forsberg - 2021-09-11, 7:05
RE: General Grievous - by Bertrand Lequy - 2021-09-11, 10:19
RE: General Grievous - by Magnus Forsberg - 2021-09-11, 13:23
|
Users browsing this thread: 2 Guest(s)