Hi Jetro,
"LOCAL" works here. As far as I can tell "0 !LPUB ASSEM MODEL_SCALE <scale>" means change scale from now on, while
"0 !LPUB ASSEM MODEL_SCALE LOCAL <scale>" changes scale only for one step.
Right click on assembly, then "change scale" to use.
It's a bit tricky if you want to have the scale change appear in a multistep page as !LPUB ASSEM MODEL_SCALE affects all steps on page, regardless of the step you applied it, but it can be managed with "LOCAL".
Note that I have not tried in a multi-subfile model, just on linear instructions, changing scale from 1 to 2 then back to 1 a few steps later.
"LOCAL" works here. As far as I can tell "0 !LPUB ASSEM MODEL_SCALE <scale>" means change scale from now on, while
"0 !LPUB ASSEM MODEL_SCALE LOCAL <scale>" changes scale only for one step.
Right click on assembly, then "change scale" to use.
It's a bit tricky if you want to have the scale change appear in a multistep page as !LPUB ASSEM MODEL_SCALE affects all steps on page, regardless of the step you applied it, but it can be managed with "LOCAL".
Note that I have not tried in a multi-subfile model, just on linear instructions, changing scale from 1 to 2 then back to 1 a few steps later.
Quote:I have looked for a complete list of metacommands for LPUBThere is Help -> save LPUB metacommands to file, but it doesn't seem to be up to date....!!!