If there is a meta-point on a part that you need noted that is not covered by the origin, you could propose new meta command to annotate points of interest on a part; MLCad's unofficial ROTATION CENTER meta is, I think, an example of this. People seem pretty resistant to adding new meta-commands though.
LDraw.org Discussion Forums
›
Models and Parts
›
Parts Authoring
Proposal to change points of origin
Proposal to change points of origin
Proposal to change points of origin
« Next Oldest | Next Newest »
| Messages In This Thread |
|
Proposal to change points of origin - by Massimo Maso - 2014-03-30, 22:03
Re: Proposal to change points of origin - by Santeri Piippo - 2014-03-30, 22:18
Re: Proposal to change points of origin - by Willy Tschager - 2014-03-31, 18:13
Re: Proposal to change points of origin - by Ben Supnik - 2014-03-31, 21:23
Re: Proposal to change points of origin - by Travis Cobbs - 2014-03-31, 21:36
Re: Proposal to change points of origin - by Steffen - 2014-04-01, 2:22
Re: Proposal to change points of origin - by Ben Supnik - 2014-04-02, 4:47
|
Users browsing this thread: 1 Guest(s)