Yes, some more information on the supported version would be helpful:
>For both the SolidWorks and Inventor translators, you can try to run them with older versions.
It would also be helpful if you could code in some backwards compatibility. I only have access to a very old version of Soldiworks, 2007 to be precise and SolidWorks Brick Builder failed to find Solidworks in the first place.
Since we are there would it be possible to convert, without Solidworks or Inventor installed. Say, just write a .dxf or .SLDPRT to the disk?
Last thing. All setup files are named Setup.exe a rename to Setup_SolidWorks_Brick_Builder.exe or Setup_Inventor_Brick_Builder.exe would help.
Thanks, w.
>For both the SolidWorks and Inventor translators, you can try to run them with older versions.
It would also be helpful if you could code in some backwards compatibility. I only have access to a very old version of Soldiworks, 2007 to be precise and SolidWorks Brick Builder failed to find Solidworks in the first place.
Since we are there would it be possible to convert, without Solidworks or Inventor installed. Say, just write a .dxf or .SLDPRT to the disk?
Last thing. All setup files are named Setup.exe a rename to Setup_SolidWorks_Brick_Builder.exe or Setup_Inventor_Brick_Builder.exe would help.
Thanks, w.
LEGO ergo sum