How to "inline" a sub-model?
2013-11-16, 20:55 (This post was last modified: 2014-08-23, 13:55 by Michael Heidemann.)
2013-11-16, 20:55 (This post was last modified: 2014-08-23, 13:55 by Michael Heidemann.)
I noticed that Tore Eriksson "inlined" a lot of parts in Datsville in the past. I'm not sure exactly what that means, but I'm guessing it means removing a model from a sub-assembly and placing it in a higher-level parent model without messing up the model's position.
I would like to do the same. I would like to extract minifigures from within individual MPD models and place them in a higher "traffic" layer without screwing up their positions.
Am I being clear? How do I accomplish this?
I would like to do the same. I would like to extract minifigures from within individual MPD models and place them in a higher "traffic" layer without screwing up their positions.
Am I being clear? How do I accomplish this?