A couple of observations:
1. I wish you had retained LEdit/MLCAD's part movement commands. For large models like Datsville the on-screen controls are too sluggish/unresponsive to be really useful.
2. I think you should map the middle mouse button to panning the camera. The Selection Properties menu is already accessible from the right-click menu which is already pretty convenient IMO.
3. Is there a way to switch to a "camera movement only" mode where dragging the mouse across the screen does _not_ move the selected part?
4. The part bounding boxes seem to be exaggerated a bit. I.e. they're slightly larger than the actual part. This is a little confusing when trying to align parts next to each other. Is there a way to make the bounding match the part's contours exactly?
1. I wish you had retained LEdit/MLCAD's part movement commands. For large models like Datsville the on-screen controls are too sluggish/unresponsive to be really useful.
2. I think you should map the middle mouse button to panning the camera. The Selection Properties menu is already accessible from the right-click menu which is already pretty convenient IMO.
3. Is there a way to switch to a "camera movement only" mode where dragging the mouse across the screen does _not_ move the selected part?
4. The part bounding boxes seem to be exaggerated a bit. I.e. they're slightly larger than the actual part. This is a little confusing when trying to align parts next to each other. Is there a way to make the bounding match the part's contours exactly?