Thanks for the file.
I just loaded this file into DATHeader 3.0.12.0.
I can confirm that the problem reported for the !CATEGORY entry depends on the first word of the part description. The first word of the description is already a word that is present in the official category list and therefore it is wasting space to repeat that word in a separate category statement. If you would choose another category no error is reported.
So at this point I can not give a better answer now.
I just loaded this file into DATHeader 3.0.12.0.
I can confirm that the problem reported for the !CATEGORY entry depends on the first word of the part description. The first word of the description is already a word that is present in the official category list and therefore it is wasting space to repeat that word in a separate category statement. If you would choose another category no error is reported.
Ronald Vallenduuk Wrote:When it's optimising I noticed it's changed some triangles. For example this:I can not find that source line in the file you provided. If I try to do optimizing I am told by DATHeader that no optimization can be done ??
3 16 -16 8 20 -9.876 8 22.903 -2 8 22.961
was change to this:
3 16 -2 8 22.961 -16 8 20 -9.876 8 22.903
So at this point I can not give a better answer now.