Brick 1x1 with curved top

[SNIPE]

Hi, I made a quick mocup of an upcoming part, it is simular to part 6091 but withot the 1x1 plate. or a 1x1 version of part 37352

I saw it in this post: https://www.newelementary.com/2024/11/ne...e-kid.html

Here is the file, I'm not sure how to add snapping information for the clutch without modifying the ldcad shadow library.


  1x1 curved brick.dat (Size: 1.21 KB / Downloads: 7)

There is also no know part ID for it yet.

[Gerald Lasser]

I thinkit is one plate too high

[SNIPE]

I thinkit is one plate too high

oh actuallly yeah...

well, I've ran out of talent as I can only do very basic parts editing. 

(I made this by just commenting out lines from 6091.dat until it loooked right, I then removed one of the faces as there was another one I could stretch to fit on the rectangular side section of the part and that was about it).

So I'll just wait until someone else makes it 🙂

[SNIPE]

I made a better version but it has 2 short lines on the back which im not sure how to remove and obvioustly no snapping on the clutch

  7126.dat (Size: 1.79 KB / Downloads: 3)