+- LDraw.org Discussion Forums (https://forums.ldraw.org)
+-- Forum: Models and Parts (https://forums.ldraw.org/forum-18.html)
+--- Forum: Parts Authoring (https://forums.ldraw.org/forum-19.html)
+--- Thread: Brick 1x1 with curved top (/thread-28504.html)
Brick 1x1 with curved top - SNIPE - 2024-11-11
Hi, I made a quick mocup of an upcoming part, it is simular to part 6091 but withot the 1x1 plate. or a 1x1 version of part 37352
I saw it in this post: https://www.newelementary.com/2024/11/new-parts-january-2025-lego-monkie-kid.html
Here is the file, I'm not sure how to add snapping information for the clutch without modifying the ldcad shadow library.
1x1 curved brick.dat (Size: 1.21 KB / Downloads: 6)
There is also no know part ID for it yet.
RE: Brick 1x1 with curved top - Gerald Lasser - 2024-11-11
I thinkit is one plate too high
RE: Brick 1x1 with curved top - SNIPE - 2024-11-12
(2024-11-11, 23:08)Gerald Lasser Wrote: I thinkit is one plate too high
oh actuallly yeah...
well, I've ran out of talent as I can only do very basic parts editing.
(I made this by just commenting out lines from 6091.dat until it loooked right, I then removed one of the faces as there was another one I could stretch to fit on the rectangular side section of the part and that was about it).
So I'll just wait until someone else makes it 🙂
RE: Brick 1x1 with curved top - SNIPE - 2024-12-20
I made a better version but it has 2 short lines on the back which im not sure how to remove and obvioustly no snapping on the clutch
7126.dat (Size: 1.79 KB / Downloads: 2)