Flag 2 x 2 with Blue and Yellow Rectangle Pattern (Sticker)
7 hours ago (This post was last modified: 7 hours ago by Eugen.)
7 hours ago (This post was last modified: 7 hours ago by Eugen.)
I just authored draft of 2335pb024.dat part (from 3825-1 and 3833-1 sets)
Actually sticker bundled directly inside part for testing purposes (as I don't know what ID sticker has and what LDraw part name sticker part should be assigned to).
Check it, is it good enough for representing real brick.
Note: I'm releasing part into Public Domain under CC0
Any suggestions on how to improve are welcome.
LeoCAD screenshot:
- Photo of real part: https://www.bricklink.com/catalogItemIn....pb024&in=S
- Sticker sheet:
Actually sticker bundled directly inside part for testing purposes (as I don't know what ID sticker has and what LDraw part name sticker part should be assigned to).
Check it, is it good enough for representing real brick.
Note: I'm releasing part into Public Domain under CC0
Code:
0 FILE
0 Flag 2 x 2 with Blue and Yellow Rectangle Pattern (Sticker)
0 Name: 2335pb024.dat
0 Author: Eugen [Eugen]
0 !LDRAW_ORG Part UPDATE 2024-08
0 !LICENSE Licensed under CC0 : see CAreadme.txt
0 !KEYWORDS Set 3825, Set 3833
1 16 0 0 0 1 0 0 0 1 0 0 0 1 11055.dat
1 16 2 20 30 0 -1 0 0 0 -1 1 0 0 sticker.dat
1 16 -2 20 30 0 1 0 0 0 -1 -1 0 0 sticker.dat
0 NOFILE
0 FILE sticker.dat
0
0 Name: sticker.dat
0 Author:
1 16 0 -0.25 0 18 0 0 0 0.25 0 0 0 18 box5-12.dat
4 1 18 -0.25 18 18 -0.25 0 -18 -0.25 0 -18 -0.25 18
4 14 18 -0.25 0 18 -0.25 -18 -18 -0.25 -18 -18 -0.25 0
0 NOFILE
Any suggestions on how to improve are welcome.
LeoCAD screenshot: