Ball bearing

[Knud Ahrnell Albrechtsen]

Hi

I know this is an unusual  request, but could you please make a ball bearing part that fits in the hole of a Technic brick and the inner diameter fits to a Train metal axle (part x1687).

I need this to do instructions to train boogies that use these ball bearings.

Dimensions: 2x5x2.5mm



Thanks
Knud

[Philippe Hurbain]

Hi

I know this is an unusual  request, but could you please make a ball bearing part that fits in the hole of a Technic brick and the inner diameter fits to a Train metal axle (part x1687).

Do you have a link to these ball bearings? (I guess they are avalable somewhere on the web?)

[Knud Ahrnell Albrechtsen]

Hi

I know this is an unusual  request, but could you please make a ball bearing part that fits in the hole of a Technic brick and the inner diameter fits to a Train metal axle (part x1687).

Do you have a link to these ball bearings? (I guess they are avalable somewhere on the web?)

Hi Philippe
Here is the link:
https://www.ebay.com/itm/401163945360
or:
https://www.ebay.com/itm/10-MR52ZZ-2x5x2...0011.m1850

[Knud Ahrnell Albrechtsen]

Hi

I know this is an unusual  request, but could you please make a ball bearing part that fits in the hole of a Technic brick and the inner diameter fits to a Train metal axle (part x1687).

Do you have a link to these ball bearings? (I guess they are avalable somewhere on the web?)

Hi again Philippe

Was it something you were interrested in working on?
if yes do you have a status?

Kind Regards
Knud

[Philippe Hurbain]

Was it something you were interrested in working on?

Sorry Knud, completely forgot... It shouldn't prove very difficult to model...

[Knud Ahrnell Albrechtsen]

[quote pid='29910' dateline='1542707122']
Was it something you were interrested in working on?

Sorry Knud, completely forgot... It shouldn't prove very difficult to model...
[/quote]

No problem

Thanks for working on it.

/Knud

[Philippe Hurbain]

Done... No attempt to model the balls themselves as it seems completely sealed.

Anyone thinks it would be worth adding it as a third party part on PT?

[Hebben]

Done... No attempt to model the balls themselves as it seems completely sealed.

Anyone thinks it would be worth adding it as a third party part on PT?

I would really like to use this part too... I can't seem to access it. Maybe I am doing something wrong? Never mind... got it!