Hi
I know this is an unusual request, but could you please make a ball bearing part that fits in the hole of a Technic brick and the inner diameter fits to a Train metal axle (part x1687).
I need this to do instructions to train boogies that use these ball bearings.
Dimensions: 2x5x2.5mm
Thanks
Knud
(2018-11-02, 12:00)Knud Ahrnell Albrechtsen Wrote: [ -> ]Hi
I know this is an unusual request, but could you please make a ball bearing part that fits in the hole of a Technic brick and the inner diameter fits to a Train metal axle (part x1687).
Do you have a link to these ball bearings? (I guess they are avalable somewhere on the web?)
(2018-11-02, 12:22)Philippe Hurbain Wrote: [ -> ] (2018-11-02, 12:00)Knud Ahrnell Albrechtsen Wrote: [ -> ]Hi
I know this is an unusual request, but could you please make a ball bearing part that fits in the hole of a Technic brick and the inner diameter fits to a Train metal axle (part x1687).
Do you have a link to these ball bearings? (I guess they are avalable somewhere on the web?)
Hi again Philippe
Was it something you were interrested in working on?
if yes do you have a status?
Kind Regards
Knud
Quote:Was it something you were interrested in working on?
Sorry Knud, completely forgot... It shouldn't prove very difficult to model...
(2018-11-20, 10:20)Philippe Hurbain Wrote: [ -> ][quote pid='29910' dateline='1542707122']
Was it something you were interrested in working on?
Sorry Knud, completely forgot... It shouldn't prove very difficult to model...
[/quote]
No problem
Thanks for working on it.
/Knud
Done... No attempt to model the balls themselves as it seems completely sealed.
Anyone thinks it would be worth adding it as a third party part on PT?
(2018-11-20, 12:39)Philippe Hurbain Wrote: [ -> ]Done... No attempt to model the balls themselves as it seems completely sealed.
Anyone thinks it would be worth adding it as a third party part on PT?
I would really like to use this part too... I can't seem to access it. Maybe I am doing something wrong? Never mind... got it!