Request: Mark part as obsolete

[Manfred Schaefer]

Hello,

This concerns minifigure upper parts 76382p4v and 76382p4y.
Only the front of 76382p4v is printed.
Both sides of 76382p4y are printed.
According to the Bricklink reference, the same pattern pb0537 is used.
There is a separate torso for each minifigure upper part.
However, I have only found this minifigure upper part with a two-sided pattern.

My suggestion is to set torso 973p4v to obsolete and change the reference in 76382p4v to torso 973p4y.

Best regards,

Manfred

[Orion Pobursky]

Bricklink lists 2 distinct parts, Rebrickable agrees
https://www.bricklink.com/v2/catalog/cat...1#T=C&C=69

https://www.bricklink.com/v2/catalog/cat...2#T=C&C=69

[Manfred Schaefer]

Bricklink lists 2 distinct parts, Rebrickable agrees
https://www.bricklink.com/v2/catalog/cat...1#T=C&C=69

https://www.bricklink.com/v2/catalog/cat...2#T=C&C=69

That's right, I'm referring to the torso, which according to Bricklink has the same pattern on both parts.
In my opinion, the torso that only has a pattern on the front (973p4v) could be considered obsolete.

[Orion Pobursky]

According to both sites, both the unpatterned and patterned back exist.