Part snapping plate 1x1 round in LDCad is difficult?


Re: Part snapping plate 1x1 round in LDCad is difficult?
#6
It's probably caused by the whole outer shape having a single snap info (so it also snaps into beam holes). The shape/size of that info (bounding box) makes it more likely to 'win' the connection tests.

I'll see if I can improve that behavior somehow. If it really bothers you you could replace the outer shape by just a simple stud one.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Re: Part snapping plate 1x1 round in LDCad is difficult? - by Roland Melkert - 2016-03-22, 20:10

Forum Jump:


Users browsing this thread: 2 Guest(s)