Cutting down sticker images to the correct size?


Cutting down sticker images to the correct size?
#1
I was going to have a go at making the stickers for the Ancient Moon-Gazing Inn set once I have done the rest of the torsos (and maybe had a go at making the minifig heads if I can)

I can get the images from BI, but those have extra design since they just scan the whole sticker plus they leave the black sticker boarder on most of the time too. So is there an easy way to cut down the images to the correct sizes in photoshop or something?  Removing the black boarder is easy enough its how much to chop off of the rest of the image so I don't make them either too big or too small.

Or is it easier to use the sticker scans from Bricklink or Rebrickable instead of BI? as you can usually see the edges of the part you peel away most of the time?

Also I am not entirely sure how you do the formed version of stickers if they go on slopes / curved parts either.
Reply
RE: Cutting down sticker images to the correct size?
#2
As for sizes, I usually take a scanned/photographed version from whatever source available (Brickset/Ebay are often better than BL/RB in that regard). A sticker applied to a tile is even better for reference.

From there on using Photoshop/GIMP to fit to a rectangle of known size and then good to go.

Not sure about the BI ones, but size reference is too bad/vague for those IMO.

As for formed stickers:

If there's an existing one (that's not older than 2024-2025) use that as a template. If not, make the flat one first, then project the full, plain sticker on the "target" surface as if it's a regular pattern. That creates the basic shape.
Take that shape, extrude it by 0.25 LDU (I use Blender for that) and then extract the top surface from that file to use as final template in LDPC.
Reply
RE: Cutting down sticker images to the correct size?
#3
(2026-11-17, 2:39)Peter Grass Wrote: I was going to have a go at making the stickers for the Ancient Moon-Gazing Inn set once I have done the rest of the torsos (and maybe had a go at making the minifig heads if I can)

I can get the images from BI, but those have extra design since they just scan the whole sticker plus they leave the black sticker boarder on most of the time too. So is there an easy way to cut down the images to the correct sizes in photoshop or something?  Removing the black boarder is easy enough its how much to chop off of the rest of the image so I don't make them either too big or too small.

Or is it easier to use the sticker scans from Bricklink or Rebrickable instead of BI? as you can usually see the edges of the part you peel away most of the time?

Also I am not entirely sure how you do the formed version of stickers if they go on slopes / curved parts either.
The BIA sticker files also have 3D meshes for each sticker. If you export them as .obj then UV-map BIA PNGs on that with Blender, you'll get the exact intended size/scaling.
Reply
« Next Oldest | Next Newest »



Forum Jump:


Users browsing this thread: 1 Guest(s)