I was going to have a go at making the stickers for the Ancient Moon-Gazing Inn set once I have done the rest of the torsos (and maybe had a go at making the minifig heads if I can)
I can get the images from BI, but those have extra design since they just scan the whole sticker plus they leave the black sticker boarder on most of the time too. So is there an easy way to cut down the images to the correct sizes in photoshop or something? Removing the black boarder is easy enough its how much to chop off of the rest of the image so I don't make them either too big or too small.
Or is it easier to use the sticker scans from Bricklink or Rebrickable instead of BI? as you can usually see the edges of the part you peel away most of the time?
Also I am not entirely sure how you do the formed version of stickers if they go on slopes / curved parts either.
I can get the images from BI, but those have extra design since they just scan the whole sticker plus they leave the black sticker boarder on most of the time too. So is there an easy way to cut down the images to the correct sizes in photoshop or something? Removing the black boarder is easy enough its how much to chop off of the rest of the image so I don't make them either too big or too small.
Or is it easier to use the sticker scans from Bricklink or Rebrickable instead of BI? as you can usually see the edges of the part you peel away most of the time?
Also I am not entirely sure how you do the formed version of stickers if they go on slopes / curved parts either.