[Complete] Missing Roboforce 1997 Minifigure Pieces

[Zack Uhlenhuth]

Would be awesome if someone could get the custom roboforce legs into LDraw!

Chip Nebula legs:
* https://rebrickable.com/parts/970c03pr99...try-print/
* https://rebrickable.com/parts/970c03pr99...try-print/

[Zack Uhlenhuth]

would be great to get in these bricks too
https://rebrickable.com/parts/3298pr0034...try-print/
https://rebrickable.com/parts/3039pr9981...try-print/

[Chris Böhnke]

Robo Force Legs:
Red:
https://library.ldraw.org/parts/53915

Yellow:
https://library.ldraw.org/parts/53911

[Zack Uhlenhuth]

Awesome! These are great

[Zack Uhlenhuth]

Slight nitpick, but it does seem like the top of the print for the legs is cut off?

Going to mark this as Complete anyways!

[Chris Böhnke]

I would tend to agree, but the print goes into an area, where the base part would need adjustment, which is really, really not wanted

It's barely visible, even on the real part, so the important criteria should be the position of the print relative to the "toes", IMO.

I might do the slopes once all the minifig parts are done. Not on your list, but I already have a 60-70% done 6069pb02 begun a year ago or so

[Zack Uhlenhuth]

This site has a pretty good image that shows that the top circle along the top is a complete circle (not cut off): https://www.merlinsbricks.com/minifigs/sp035/

Sounds good about the slopes as well!