Hello,
I'm using part 24093p03 in a set of assembly instructions in LPub3D. The representation in the PLI is unsuitable. The page with the pattern isn't visible.
Pic1.JPG (Size: 4.85 KB / Downloads: 8)
So I wanted to change this representation and created a corresponding entry in the PLI.mpd file.
Pic2.JPG (Size: 17.49 KB / Downloads: 6)
However, it didn't work.
How can I get LPub3D to use the new representation in the PLI?
Thank you.
Best regards,
Manfred
I'm using part 24093p03 in a set of assembly instructions in LPub3D. The representation in the PLI is unsuitable. The page with the pattern isn't visible.
Pic1.JPG (Size: 4.85 KB / Downloads: 8)
So I wanted to change this representation and created a corresponding entry in the PLI.mpd file.
Pic2.JPG (Size: 17.49 KB / Downloads: 6)
However, it didn't work.
How can I get LPub3D to use the new representation in the PLI?
Thank you.
Best regards,
Manfred