LDraw.org Discussion Forums › Models and Parts › Parts Authoring v
Is there any demand for a stud4s with no edge lines?

Is there any demand for a stud4s with no edge lines?


Mark Kennedy Offline
Seasoned LDrawer ***
PTSubmit
Posts: 84
Threads: 30
Joined: Jun 2012
Is there any demand for a stud4s with no edge lines?
#1
Question  9 hours ago
Mainly this primitive would be used in parts where the top of the stud goes into the part so the edge lines that would be drawn in the primitive would not show up.
Find
Reply
Gerald Lasser Offline
Administrator *******
Administrators James Jessiman Memorial LDraw Member PTAdmin PTSubmit Steering Committee
Posts: 1,720
Threads: 79
Joined: Sep 2011
RE: Is there any demand for a stud4s with no edge lines?
#2
4 hours ago
(9 hours ago)Mark Kennedy Wrote: Mainly this primitive would be used in parts where the top of the stud goes into the part so the edge lines that would be drawn in the primitive would not show up.

I just posted the same thought into the concerned (sub) part :-)

I do not see the big issue now with the hidden edge line, but we could add one nevertheless
Find
Reply
Mark Kennedy Offline
Seasoned LDrawer ***
PTSubmit
Posts: 84
Threads: 30
Joined: Jun 2012
RE: Is there any demand for a stud4s with no edge lines?
#3
2 hours ago (This post was last modified: 2 hours ago by Mark Kennedy.)
(4 hours ago)Gerald Lasser Wrote: I just posted the same thought into the concerned (sub) part :-)

I do not see the big issue now with the hidden edge line, but we could add one nevertheless
It could end up being an issue on transparent parts, but then so would the rest of the stud4s, just to a lesser extent.
Find
Reply
« Next Oldest | Next Newest »



Forum Jump:


Users browsing this thread: 1 Guest(s)