Searching for rects


Searching for rects
#1
How can I search for my (sub)parts that contain rect-primitives on the tracker?
Reply
RE: Searching for rects
#2
I think this should work

Go to "Part List"

Set the "!LDRAW_ORG Type" to "Subpart"
Add a Filter "Author" select yourself "WUIt"
Add another Filter "Body" set opertator to "Contains" Text "rect"

That gives around 40 parts

But honestly if a rect has only integers or 2 decimals I would not bother changing it. 
THe other reasonstated that edge lines might be doubled, can be found, same argement then also for the boxes...
Reply
RE: Searching for rects
#3
Thanks Gerald

I inlined the rects in 51261s01 because it was preventing four parts from being approved by admins.
Reply
RE: Searching for rects
#4
(2025-08-30, 12:17)Peter Blomberg Wrote: Thanks Gerald

I inlined the rects in 51261s01 because it was preventing four parts from being approved by admins.

That standpoint is just one persons opinion. 
I have nothing against slanted or rotated rect prims as long as they are created correctly.
Never round of your code after you have created rect prims. Reducing decimals after creation will cause micro gaps.
Reply
RE: Searching for rects
#5
Is it possible to search for parts that have received a comment since I last uploaded it?
Reply
RE: Searching for rects
#6
there is "Events on my submits" on the User Dashboard but thats not filterable...
(and it includes everything: certs, holds, reuploads, comments)
Reply
RE: Searching for rects
#7
(2025-08-30, 23:31)Rene Rechthaler Wrote: there is "Events on my submits" on the User Dashboard but thats not filterable...
(and it includes everything: certs, holds, reuploads, comments)

Unfortunately, that list of events doesn't include submits/reuploads, so it's missing half of the information required.
Reply
« Next Oldest | Next Newest »



Forum Jump:


Users browsing this thread: 2 Guest(s)