Hi,
Is there a simple way or set of instructions to turn an .stl file (taken from SketchUp) into a Lego model? I have used Brickify, however it appears the model is too large to process so the site is hanging. I did remove unused layers, however that doesn't seem to help.
Unable to load file via the forum, so here is the link to the model via the 3D Warehouse -
https://3dwarehouse.sketchup.com/model/1...ape-May-NJ
Apologies in advance if this topic has been covered and I completely missed it.
Thanks for any and all assistance.
George
Is there a simple way or set of instructions to turn an .stl file (taken from SketchUp) into a Lego model? I have used Brickify, however it appears the model is too large to process so the site is hanging. I did remove unused layers, however that doesn't seem to help.
Unable to load file via the forum, so here is the link to the model via the 3D Warehouse -
https://3dwarehouse.sketchup.com/model/1...ape-May-NJ
Apologies in advance if this topic has been covered and I completely missed it.
Thanks for any and all assistance.
George