Technic beam orientation

Re: Technic beam orientation
Actually, I think the idea of a new meta-command has merit. It would allow the orientation and origin of any part to be corrected at any arbitrary time without having a negative impact on existing files. LDraw editors would have to support the command, but it would only be used by editors at the time that a part is added to the model. The meta would simply contain a standard LDraw transformation matrix (just like type 1 lines contain), and if present, this transform would be applied by editors when the part is added. (LPub might also pay attention to the command to orient the part in the BOM; I'm not sure about that, though.)
« Next Oldest | Next Newest »

Messages In This Thread
Technic beam orientation - by Roland Melkert - 2012-06-05, 22:47
Re: Technic beam orientation - by Steffen - 2012-06-07, 20:00
Re: Technic beam orientation - by Travis Cobbs - 2012-06-07, 22:25

Forum Jump:

Users browsing this thread: 1 Guest(s)