Are standards for official parts too strict?


Re: Are standards for official parts too strict?
#45
when the removal of 0 lines isn't documented anywhere, I think it is legitimate to assume that forbidding them was an unwanted spec glitch.
as far as I remember the discussions of those days, the special case "a single 0 on a line" was intended to be explicitly allowed, because some people use it as a separator
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Re: Are standards for official parts too strict? - by Steffen - 2013-01-17, 0:11

Forum Jump:


Users browsing this thread: 2 Guest(s)