Baseplate underdetailing was Re: LDView Bug


Re: Baseplates with underdetails was Re: LDView Bug
#20
I have a few comments. First of all, it's p/48, not p/64 (very minor point). A bigger point is that the baseplates with underside studs are completely differently modeled from the others since they use big polygons for their entire top and bottom surfaces (minus the rounded corners), and then just stick the studs on top of the top one. So baseplates have to have completely different versions in order for this to work. Splitting the existing baseplates over to using the updated baseplate stud dimple would introduce a huge amount of extra geometry.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Re: LDView Bug - by Jean-Philippe Ouellet - 2012-01-16, 22:46
Re: LDView Bug - by Tim Gould - 2012-01-16, 22:50
Re: LDView Bug - by Jean-Philippe Ouellet - 2012-01-16, 23:56
Re: LDView Bug - by Tim Gould - 2012-01-17, 2:13
Re: LDView Bug - by Philippe Hurbain - 2012-01-17, 8:16
Re: Baseplates with underdetails was Re: LDView Bug - by Travis Cobbs - 2012-01-18, 16:02

Forum Jump:


Users browsing this thread: 2 Guest(s)