Is 5404.dat correct?


RE: Is 5404.dat correct?
#2
(2024-03-05, 22:50)SNIPE Wrote: Hi,

I'm just wondering if part 5404.dat is correct, because the 1x1 cheese slope and 2x1 grille slope is 2.5 plats high, but it look slike part 5404 is slightly higher:

[Image: welp.png]

I think the bottom lip is slightly too high compared to the other 2 parts
Regards, SNIPE

Thnaks for posting this, I wanted to discuss this already after I uploaded the part and then played around with it.
The slopes are two plates high.

The bottom Lip is currently 5 LDU (as is the new cheese grater), the 54200 is 4 LDU

THe raw file from the app is also using 5 LDU. using this geometry, even adapted does not allow this set up, as it cuts into the brick:
   

However due to tolerances etc this is possible in real life (as I got the parts), so I would lower the Lip to 4, which would then give us a 20 LDU high part

Edit: The real life situation is closer to the drawing at the bottom left, interesting...
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Is 5404.dat correct? - by SNIPE - 2024-03-05, 22:50
RE: Is 5404.dat correct? - by Gerald Lasser - 2024-03-06, 19:27
RE: Is 5404.dat correct? - by SNIPE - 2024-03-06, 22:11

Forum Jump:


Users browsing this thread: 1 Guest(s)