LDraw.org Discussion Forums › General › General LDraw.org Discussion v
3023a?

3023a?


Jaco van der Molen Offline
LDraw.org Moderator ******
PTSubmit
Posts: 1,259
Threads: 177
Joined: Jul 2011
RE: 3023a?
#9
2023-07-11, 11:46
I got a bit scared too once I noticed the snapping of good old 1x2 plate didn't work anymore.
Only then today doing some modelling again to notice 3023 was moved to 3023b....
All models that use 3023 still work fine though as to be expected, since 3023.dat still exists.
Jaco van der Molen
lpub.binarybricks.nl
Find
Reply
« Next Oldest | Next Newest »



Messages In This Thread
3023a? - by Steve - 2023-07-04, 21:19
RE: 3023a? - by Orion Pobursky - 2023-07-04, 21:39
RE: 3023a? - by Steve - 2023-07-06, 0:37
RE: 3023a? - by Rene Rechthaler - 2023-07-06, 16:01
RE: 3023a? - by Orion Pobursky - 2023-07-06, 16:58
RE: 3023a? - by Roland Melkert - 2023-07-07, 22:10
RE: 3023a? - by Magnus Forsberg - 2023-07-08, 7:36
RE: 3023a? - by Roland Melkert - 2023-07-08, 18:14
RE: 3023a? - by Jaco van der Molen - 2023-07-11, 11:46
RE: 3023a? - by Steve - 2023-07-30, 22:54
RE: 3023a? - by Steve - 2023-07-31, 23:04
RE: 3023a? - by Roland Melkert - 2023-07-31, 23:41

Forum Jump:


Users browsing this thread: 1 Guest(s)