[LDPE] 1.8.61 Released (mixed-mode tori)

RE: [LDPE] change "winding" of lines
As a user I'd like the change winding tool (j) to be also active on type 2 lines, swapping the end points. This is useful when preparing the shape files for pathtruder since the winding of surfaces generated by this tool depends on end points order.
« Next Oldest | Next Newest »

Messages In This Thread
RE: [LDPE] change "winding" of lines - by Philippe Hurbain - 2023-01-06, 13:23

Forum Jump:

Users browsing this thread: 1 Guest(s)