LDCad Rubber band templates question


Rubber band templates question
#1
For band/belt templates in LDCad, the radius of a point is measured to the center of the path. I thought it would be handy to offset the path skin so that its inner edge follow the radius (i.e., the radius of the point is the same as the part it goes around).

I thought adjusting the alignment parameter was the way to do this, but it didn't work. It just breaks the path into segments with wide gaps (and they aren't noticeably offset from center).

Is there a simple way to adjust the template to do this? Or would I have to create a donor part with the origin shifted (and would that even work)?
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Rubber band templates question - by N. W. Perry - 2021-09-10, 15:40

Forum Jump:


Users browsing this thread: 1 Guest(s)