BEAD004 From Lego Pens

[SNIPE]

Thanks, Fixed:

1 16 0 4 0 1 0 0 0 -6.5 0 0 0 1 stud4a.dat

0 BFC INVERTNEXT
1 16 0 30 0 12 0 0 0 -26 0 0 0 12 box4.dat
1 16 0 4 0 8 0 0 0 -1 0 0 0 8 4-4ndis.dat
4 16 -12 30 -12 12 30 -12 15 30 -15 -15 30 -15
4 16 12 30 -12 12 30 12 15 30 15 15 30 -15
4 16 12 30 12 -12 30 12 -15 30 15 15 30 15
4 16 -12 30 12 -12 30 -12 -15 30 -15 -15 30 15

1 16 0 30 0 15 0 0 0 -30 0 0 0 15 box4.dat
1 16 0 0 0 6 0 0 0 1 0 0 0 6 4-4ndis.dat
4 16 -6 0 6 6 0 6 15 0 15 -15 0 15
4 16 -6 0 6 -15 0 15 -15 0 -15 -6 0 -6
4 16 -6 0 -6 -15 0 -15 15 0 -15 6 0 -6
4 16 6 0 -6 15 0 -15 15 0 15 6 0 6

1 16 0 0 0 1 0 0 0 1 0 0 0 1 stud2a.dat
1 16 0 0 0 6 0 0 0 1 0 0 0 6 4-4edge.dat

0 BFC INVERTNEXT
1 16 0 0 0 4 0 0 0 4 0 0 0 4 4-4cyli.dat
1 16 0 4 0 4 0 0 0 1 0 0 0 4 4-4edge.dat
1 16 0 4 0 2 0 0 0 -1 0 0 0 2 4-4ring2.dat

There is a slght error where the inside and outside of the bottom tube meets the top face, there should be lines but arn't but I'm not bothered so much about that:


Regards, Snipe.