Complete 25195 Plate, Modified 2 x 6 with Pole Holder Pin


RE: 25195 Plate, Modified 2 x 6 with Pole Holder Pin
#15
(2020-04-16, 9:22)Magnus Forsberg Wrote: OK, great.
Here is a preview, of what I see on the images.


Is the height of the cylinder correct? I can't tell that from your images.
IMO the inside of the "handle with bars", 23422.dat , is too narrow. Don't think it is the same as a stud.
That upside down 1x1 brick didn't stick when you placed it on top of the cylinder. Right?

Correct. It does not stick. I have run your dat file through 4 different renders and it all looks good from UV calculation and measurements - except the inner tube width. I think it needs to be just a little bit thicker. It is currently 15 LDU:

4-4cylo.dat placed at 0 -32 0     7.5 0 0 0 40 0 0 0 7.5

I think it will me more correct with width 14:

0 -32 0      7 0 0 0 40 0 0 0 7

This is how the 15 wide tube looks around a stud:

[Image: 580.png]

Edit. I see that I agree with philo.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: 25195 Plate, Modified 2 x 6 with Pole Holder Pin - by Lasse Deleuran - 2020-04-16, 19:01

Forum Jump:


Users browsing this thread: 2 Guest(s)