Thinking about doing a LDCad 1.7 version


RE: Thinking about doing a LDCad 1.7 version
#3
(2020-01-13, 23:01)N. W. Perry Wrote: A second idea I had recently, and I don't know how trivial or complicated this would be, but is it possible to have step numbering that starts at a number other than 1? So for example, you start a new submodel and specify that its step numbering begins with Step 24 (to match official instructions)?

This is very easy to do in LPub3D.
Configuration ---> Build Instructions Setup... ---> Project Setup: Activate "Continous step numbers"


.png   LPub3D.PNG (Size: 15.63 KB / Downloads: 832)

Or insert following meta:
0 !LPUB CONTINUOUS_STEP_NUMBERS GLOBAL TRUE
If nothing goes right, go left.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: Thinking about doing a LDCad 1.7 version - by Johann Eisner - 2020-01-14, 7:56

Forum Jump:


Users browsing this thread: 3 Guest(s)