Patterned Baseplates


RE: Patterned Baseplates
#14
(2019-07-03, 22:39)Mikkel Bech Jensen Wrote: These baseplates rarely had the patterns correctly aligned. It is not unusual to see two instances of the same set with baseplate patterns off by a stud or two. In this case it is very difficult to say if your version is off by a stud or mine was off by a stud. I just tried to make shure that the river would be perfectly aligned with the opposite end so multiple baseplates could be placed from each end and look consistent.

Awsome looking Enchanted Island! Big Grin  I haven't even made it myself in ldraw. Someone needs to make the corner wall rock & leaf pattern

Absolutely.  There's so many that need to be made, but we cannot expect the moon.  I'm realistic.

Was going to take a stab at the other two baseplates, but frankly don't have the patience anymore (too busy with two startups).  I'm taking a couple classes in the fall in design.  Maybe I can get the baseplates read into a file from a 3D scanner there, then do something with them.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Patterned Baseplates - by Matthew Renner - 2019-06-30, 16:39
RE: Patterned Baseplates - by Gerald Lasser - 2019-06-30, 22:27
RE: Patterned Baseplates - by Matthew Renner - 2019-06-30, 23:28
RE: Patterned Baseplates - by Matthew Renner - 2019-07-01, 16:28
RE: Patterned Baseplates - by Willy Tschager - 2019-07-01, 16:28
RE: Patterned Baseplates - by Gerald Lasser - 2019-07-01, 21:24
RE: Patterned Baseplates - by Matthew Renner - 2019-07-01, 23:21
RE: Patterned Baseplates - by Matthew Renner - 2019-07-03, 22:52
RE: Patterned Baseplates - by Gerald Lasser - 2019-07-06, 11:46
RE: Patterned Baseplates - by Steffen - 2019-07-09, 6:41
RE: Patterned Baseplates - by Gerald Lasser - 2019-07-09, 11:59
RE: Patterned Baseplates - by Gerald Lasser - 2019-07-09, 17:36

Forum Jump:


Users browsing this thread: 1 Guest(s)