Looking a tutorial to make a custom part!


RE: Looking a tutorial to make a custom part!
#19
(2019-10-24, 14:45)Philippe Hurbain Wrote: Your LDraw code is a bit wrong, since it uses a part with front face  and overlaps a front face with texmapped pattern. Attached a more correct version.
...but I doubt this is the source of your problem.
LDview renders front face as opaque:

and LDCad renders the pattern as transparent:

Also with your code i'm still getting the same behavior.
I thought I got the same result that you got with ldview. Where could I have gone wrong? Do I need to enable a particular setting on the LDview render engine?
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: Looking a tutorial to make a custom part! - by Simone - 2019-10-24, 15:02

Forum Jump:


Users browsing this thread: 2 Guest(s)