LDCad part/step insertion at current source location vs. end?


RE: LDCad part/step insertion at current source location vs. end?
#9
(2018-05-10, 18:46)Roland Melkert Wrote: This is already supported, it's the third mode of the editing pin. It allows for moving the pin around without moving the selection. Afterwards you can go back to rotation mode.
I think I didn't explain myself very well. I know about that mode, it's not what I'm looking for. What I mean is the ability to rotate all parts in a selection individually instead of as a selection. So id I'd select 5 1x1 bricks, I would like to be able to rotate them all using their own individual axis. If that makes sense... I could make an image explaining it, if necessary.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: LDCad part/step insertion at current source location vs. end? - by Merlijn Wissink - 2018-05-11, 17:19

Forum Jump:


Users browsing this thread: 1 Guest(s)