Sticker size


RE: Sticker size
#8
(2016-08-17, 16:08)Magnus Forsberg Wrote:
(2016-08-16, 23:11)Willy Tschager Wrote: where does this information come from? Cannot find anything related among the specs.

It might look very "official", but that's only because I wrote it like that. Smile
I'm also missing this in the specs.

(2016-08-17, 4:12)Travis Cobbs Wrote: All the size units in other part names are stud sizes, aren't they?

Yes.
1 stud = 1 brick = 20 ldu
I would say this is the correct way to describe the dimensions of a sticker.

(2016-08-17, 15:39)Chris Dee Wrote: OK - I suggest adding another bullet point in second place to read:
  • Dimensions should be specified in studs (where 1 stud = 20LDraw units), rounded to one decimal place, as [z-dimension] x [x-dimension].

Yes, please, do that.

Done.
Chris (LDraw Parts Library Admin)
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Sticker size - by Willy Tschager - 2016-08-16, 13:55
RE: Sticker size - by Magnus Forsberg - 2016-08-16, 15:30
RE: Sticker size - by Willy Tschager - 2016-08-16, 23:11
RE: Sticker size - by Travis Cobbs - 2016-08-17, 4:12
RE: Sticker size - by Willy Tschager - 2016-08-17, 11:28
RE: Sticker size - by Chris Dee - 2016-08-17, 15:39
RE: Sticker size - by Magnus Forsberg - 2016-08-17, 16:08
RE: Sticker size - by Chris Dee - 2016-08-17, 17:11

Forum Jump:


Users browsing this thread: 1 Guest(s)