For Beginners: LDCad 1.5 Part Bins for EV3 Education 45544-1


RE: For Beginners: LDCad 1.5 Part Bins for EV3 Education 45544-1
#7
For Beginners: LDCad 1.5 Part Bins for EV3 Education 45544-1, Epilog

Having the part bins set up made the learning curve for LDCad a lot easier.  I then figured out how to use LPub3D.1.3.4 to generate the building instructions I wanted.  

The robotics students study line/edge following using the standard robot described in the EV3-Education kit which has "wheelchair" steering with one motor on each side.  Students who finish that challenge early are going to be given a different configuration robot:  a front motor assembly that drives the robot and a sideways mounted motor to steer by turning the whole front assembly.

The robot only uses one piece that isn't part of the EV3-Edu kit: a thin wheel with a hard rubber tire that I can buy at BrickLink for about $0.25.  It's part 3482c03. 

LDraw file generated by LDCad 1.5 and building instructions below.

Building Instructions

Walt


Attached Files Thumbnail(s)
   

.ldr   Power Steering-LDraw.ldr (Size: 7.39 KB / Downloads: 3)
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: For Beginners: LDCad 1.5 Part Bins for EV3 Education 45544-1 - by Walt White - 2016-08-11, 19:18

Forum Jump:


Users browsing this thread: 1 Guest(s)