LPub3D 2.0.5 - Can't get fading to work with BUFEXCHG


RE: LPub3D 2.0.5 - Can't get fading to work with BUFEXCHG
#3
Trevor,

Thanks for taking a look.  Here are a couple images to demonstrate what I'm experiencing. 

In scenario 1, you see what happens when I use a BUFEXCHG RETRIEVE and then immediately add parts before displaying the results with a STEP or ROTSTEP.  In the second frame, all the additional pieces are faded when attached to the retrieved assembly.  In the fourth frame, some are faded and some are not.

   

In scenario 2, you can see that I'm getting the correct results if I add a STEP/ROTSTEP after the BUFEXCHG RETRIEVE but before I add the additional parts.  However, I don't want to see the faded assembly before I add parts.

   

Perhaps this could be fixed by adding an LPUB directive that signals sets a demarcation between faded and not-to-be faded parts in a step--the equivalent of a STEP/ROTSTEP without the display.

Once again, thanks for all your work on LPub3D.  It's an amazing tool. 

Kevin
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: LPub3D 2.0.5 - Can't get fading to work with BUFEXCHG - by Kevin - 2016-07-19, 5:00

Forum Jump:


Users browsing this thread: 1 Guest(s)