RE: LPub3D 2.0 Released
2017-01-22, 18:20 (This post was last modified: 2017-01-22, 18:20 by Merlijn Wissink.)
2017-01-22, 18:20 (This post was last modified: 2017-01-22, 18:20 by Merlijn Wissink.)
Ok, so I found another bug (kinda I think). And it would be great if you could quickly fix this one 
I want the placement of the step-number the same as in official instructions: under the parts list at the left side. So, I right-clicked the step number and positioned it at the bottom-left of the parts-list. But, then the part number went into the parts list. That's already wrong. Doesn't matter which position I chose relative to the parts-list, the part number always went to the top-left corner of the PLI.
I thought I could maybe fix it by changing the PLI position. I changed the PLI position from relative to the part-number to relative to the page (top-left corner). Then I changed the position of the step number again. Again, bottom-left relative to the PLI. But, now the part number constantly goes to the center of the page (whichever position relative to the PLI I choose)
I want the placement of the step-number the same as in official instructions: under the parts list at the left side. So, I right-clicked the step number and positioned it at the bottom-left of the parts-list. But, then the part number went into the parts list. That's already wrong. Doesn't matter which position I chose relative to the parts-list, the part number always went to the top-left corner of the PLI.
I thought I could maybe fix it by changing the PLI position. I changed the PLI position from relative to the part-number to relative to the page (top-left corner). Then I changed the position of the step number again. Again, bottom-left relative to the PLI. But, now the part number constantly goes to the center of the page (whichever position relative to the PLI I choose)