Freshly updated Ldraw.xml


Re: Freshly updated Ldraw.xml
#24
Philippe Hurbain Wrote:
Quote:It should turn 180° over y, so I put transformation ay="1", but it just won't turn.
I think it does what you asked for: rotate around ay by 0° (parameter angle="0")
Hmm, OK. I am not yet into this.
So, if I say ay=1 then the value of angle should be 3.141593.
This is Pi? Why is that?

Edit 2: after much trial and error I think the correct entry in ldraw.xml for this part should be:

<!-- 57999 Train Wheel for RC with Technic axle holder and Rubber ring-->
<Brick ldraw="55423.dat" lego="57999" />
<Transformation ldraw="55423.dat" tx="0" ty="0" tz="-0.65" ax="0" ay="1" az="0" angle="3.141593" />
Jaco van der Molen
lpub.binarybricks.nl
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Re: Freshly updated Ldraw.xml - by Jarema - 2015-09-30, 20:21
Re: Freshly updated Ldraw.xml - by Jarema - 2015-10-01, 18:36
Re: Freshly updated Ldraw.xml - by Jarema - 2015-09-30, 21:29
put ldraw.xml to github? - by Steffen - 2015-10-03, 11:31
Re: Freshly updated Ldraw.xml - by Jaco van der Molen - 2015-10-13, 13:44

Forum Jump:


Users browsing this thread: 1 Guest(s)