"Wrapping" Tool


Re: "Wrapping" Tool
#14
I looked into the templates of LDPC, the good thing there is I can use it to slice it first with the CUT command in the template. The problem is if the planes are approaching 90° compared to the initial orientation.

What was not very clear to me was if I have a facetted surface, how to define the orientation and coordinates of the different surfaces, but looking at your example, I will give that a try as well.

so {60 48; 60 -48; -60 -48; -60 48} I understand is a quad. but what does {2 96 10; 2 0 10; 2 0 130; 2 96 130} define?
Reply
« Next Oldest | Next Newest »



Messages In This Thread
"Wrapping" Tool - by Gerald Lasser - 2015-02-04, 10:06
Re: "Wrapping" Tool - by Michael Horvath - 2015-02-04, 10:19
Re: "Wrapping" Tool - by Max Martin Richter - 2015-02-04, 10:35
Re: "Wrapping" Tool - by Gerald Lasser - 2015-02-04, 11:48
Re: "Wrapping" Tool - by Philippe Hurbain - 2015-02-04, 10:42
Re: "Wrapping" Tool - by Gerald Lasser - 2015-02-04, 11:52
Re: "Wrapping" Tool - by Max Martin Richter - 2015-02-04, 12:11
Re: "Wrapping" Tool - by Nils Schmidt - 2015-02-05, 2:10
Re: "Wrapping" Tool - by Philippe Hurbain - 2015-02-05, 8:09
Re: "Wrapping" Tool - by Gerald Lasser - 2015-02-05, 8:23
Re: "Wrapping" Tool - by Max Martin Richter - 2015-02-05, 8:57
Re: "Wrapping" Tool - by Philippe Hurbain - 2015-02-05, 9:03
Re: "Wrapping" Tool - by Max Martin Richter - 2015-02-05, 9:59
Re: "Wrapping" Tool - by Gerald Lasser - 2015-02-05, 14:41
Re: "Wrapping" Tool - by Ben Supnik - 2015-02-04, 15:12
Re: "Wrapping" Tool - by Orion Pobursky - 2015-02-04, 18:56
Re: "Wrapping" Tool - by Gerald Lasser - 2015-02-04, 22:22
Re: "Wrapping" Tool - by Ben Supnik - 2015-02-05, 0:41

Forum Jump:


Users browsing this thread: 1 Guest(s)