Parts to be renamed?


Re: Parts to be renamed?
#8
Chris Dee Wrote:
-------------------------------------------------------
> Neither of these parts
> [url=http://www.ldraw.org/cgi-bin/ptdetail.cgi?s=6
> 881a]6881a[/url] and
> [url=http://www.ldraw.org/cgi-bin/ptdetail.cgi?s=6
> 881b]6881b[/url] are on the official library yet.

Whoops. This will teach me not to double check. I thought both were from the library. But the topic was meant to be more general and I'm sure I've found parts with incongruous naming in the official library.

> You raise a good point about sorting, and one that
> we probably don't pay enough attention to. For
> this reason, I am minded to re-title these and add
> Scala as a KEYWORD.

This sounds ideal.

> I think it is good to raise general philosophical
> points on this forum, but I'd really prefer that
> comments on individual files on the Parts Tracker
> are posted there so that everyone who has
> contributed to their development or review is
> notified through the daily PT digest.

Agreed. As mentioned I should have checked.

> Part names should be descriptive of form and
> function, and for this reason, I think "Scala"
> still has a place as a CATEGORY for parts that use
> a Scala Stud. However, of the exsting 9 Scala
> parts in the official library not all do.
>
>
Code:
>  6923.dat:0 Scala Tile  8 x 20 x   2/3 Round Ends
>  6934.dat:0 Scala Tile  3 x  6
>  6940.dat:0 Scala Bed  8 x 24
>  6965.dat:0 Scala Table  7 x  7 x  1 & 1/3
>  6969.dat:0 Scala Towel Bar  1 x  5
> 33008.dat:0 Scala Flower Pot
> 33029.dat:0 Scala Plate  2 x  4
> 33062.dat:0 Scala Plate  4 x  4
> 33089.dat:0 Scala Support  4 x  4 x  5.667
>
>
> I'll re-cycle the two existing "Scala Tiles" for
> header correction. Others could benefit from a
> re-examination.
>
> Chris
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Parts to be renamed? - by Tim Gould - 2011-10-30, 11:08
Re: Parts to be renamed? - by Roland Melkert - 2011-10-30, 17:51
Re: Parts to be renamed? - by Tim Gould - 2011-10-30, 23:12
Re: Parts to be renamed? - by Chris Dee - 2011-10-31, 4:13
Re: Parts to be renamed? - by Tim Gould - 2011-10-31, 22:20
Re: Parts to be renamed? - by Allen Smith - 2011-10-31, 16:07
Re: Parts to be renamed? - by Jude Parrill - 2011-10-31, 4:53
Re: Parts to be renamed? - by Tim Gould - 2011-10-31, 22:36
RE: Parts to be renamed? - by Luke Arts - 2021-03-09, 5:22
RE: Parts to be renamed? - by Willy Tschager - 2021-03-09, 14:22
RE: Parts to be renamed? - by Gerald Lasser - 2021-03-09, 23:04
Re: Parts to be renamed? - by Tim Gould - 2011-10-31, 22:26

Forum Jump:


Users browsing this thread: 1 Guest(s)