Molded "LEGO" on brick knobs


Re: Molded "LEGO" on brick knobs
#11
As far as I can tell, high-res versions of these files don't exist. However, since a high-res version of the original stud.dat doesn't exist either, as far as I know, I assume you have already done something on your end. To combine your high-res studs with the logo from version 4, simply add the following line to the bottom of your existing high-res stud.dat:

1 16 0 -4 0 1 0 0 0 1 0 0 0 1 logo4.dat
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Re: Molded "LEGO" on brick knobs - by Steffen - 2013-12-29, 11:17
Re: Molded "LEGO" on brick knobs - by Steffen - 2014-01-02, 18:12
Re: Molded "LEGO" on brick knobs - by Travis Cobbs - 2014-04-30, 16:43

Forum Jump:


Users browsing this thread: 1 Guest(s)