Request on part 6089


RE: Request on part 6919
#10
(2020-10-08, 20:01)N. W. Perry Wrote: I was actually thinking of these:


Just inverted half-cylinders (with a spherical end), I think? Can't quite make it out from photos.

Also, is the top of the stud2 flush with the rim of the dish? Or is it actually recessed a bit, as in the LDD mesh?

Ah, yes, now I understood, a picture is worth a thousand words :-)

This is in my opinion a molding artifact. The hollow stud is terminated with a smaller hole (smaller than 4 LDU) and this extends a bit further into the part and interestingly around the corner. I guess as the plastic cooled down this was pulled "inside" I should have another one as well to verify how this looks in different parts.

So no, it is not a ridge, the part is as the LDD data shows, a normal bar diameter.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Request on part 6089 - by Mikkel Bech Jensen - 2013-11-16, 21:44
RE: Request on part 6919 - by N. W. Perry - 2020-10-08, 2:01
RE: Request on part 6919 - by Gerald Lasser - 2020-10-08, 7:30
RE: Request on part 6919 - by N. W. Perry - 2020-10-08, 13:20
RE: Request on part 6919 - by Gerald Lasser - 2020-10-08, 16:09
RE: Request on part 6919 - by N. W. Perry - 2020-10-08, 20:01
RE: Request on part 6919 - by Gerald Lasser - 2020-10-08, 20:21
RE: Request on part 6919 - by N. W. Perry - 2020-10-08, 20:40
RE: Request on part 6919 - by N. W. Perry - 2020-10-12, 5:54
RE: Request on part 6919 - by Gerald Lasser - 2020-10-12, 11:36
RE: Request on part 6919 - by N. W. Perry - 2020-10-12, 15:13
RE: Request on part 6919 - by Gerald Lasser - 2020-10-12, 15:48
RE: Request on part 6919 - by N. W. Perry - 2020-10-12, 22:18
RE: Request on part 6919 - by N. W. Perry - 2020-10-13, 14:35
RE: Request on part 6919 - by N. W. Perry - 2021-06-13, 14:04
RE: Request on part 6919 - by Magnus Forsberg - 2021-06-13, 15:05

Forum Jump:


Users browsing this thread: 2 Guest(s)