I was wondering if there is a utility that can generate a cylinder of a given radius, centered on the line between two points. If I had this would be so helpful. The cylinder result would come out as an n-ncyli.dat file. Generated from the first point with the same orientation as the line.
Utility search
« Next Oldest | Next Newest »
| Messages In This Thread |
|
Utility search - by Kevin Roach - 2012-09-12, 13:56
Re: Utility search - by Philippe Hurbain - 2012-09-12, 15:56
Re: Utility search - by Michael Heidemann - 2012-09-13, 19:01
Re: Utility search - by Kevin Roach - 2012-09-14, 8:15
Re: Utility search - by Tim Gould - 2012-09-13, 22:14
Re: Utility search - by Kevin Roach - 2012-09-14, 7:56
Re: Utility search - by Tim Gould - 2012-09-14, 8:43
Re: Utility search - by Kevin Roach - 2012-09-14, 15:51
Re: Utility search - by Tim Gould - 2012-09-14, 20:48
Re: Utility search - by Kevin Roach - 2012-09-15, 5:32
Re: Utility search - by Tim Gould - 2012-09-15, 7:33
|
Users browsing this thread: 1 Guest(s)