the main focus needs to be on the 17348s01:
- we need to add the anti-stud
- we need to fit it the head (3626.dat)
Here's the geometry that need to be replaced with the primitive:
00_AntiStud.PNG (Size: 42.71 KB / Downloads: 121)
When we measure the anti-stud in the source, we see that it is roughly 4,5 LDU deep and the rim of the anti-stud is roughly 3 LDU. We can therefore not use a standard stud4 as it has a rim of 2 LDU, we need to combine some primitives:
1 14 0 -4.5 0 1 0 0 0 -1.125 0 0 0 1 stud4o.dat
1 14 0 0 0 1 0 0 0 -1 0 0 0 1 4-4ring8.dat
1 14 0 0 0 9 0 0 0 -4.5 0 0 0 9 4-4cylo.dat
Let's delete the original data and we see that there arre gaps now:
Now we need to close those gaps. The back side pocket is pretty deep in the original part, but it has no funtional purpose, so we can flatten it.
We can start adapting to the head.
- we need to add the anti-stud
- we need to fit it the head (3626.dat)
Here's the geometry that need to be replaced with the primitive:
00_AntiStud.PNG (Size: 42.71 KB / Downloads: 121)
When we measure the anti-stud in the source, we see that it is roughly 4,5 LDU deep and the rim of the anti-stud is roughly 3 LDU. We can therefore not use a standard stud4 as it has a rim of 2 LDU, we need to combine some primitives:
1 14 0 -4.5 0 1 0 0 0 -1.125 0 0 0 1 stud4o.dat
1 14 0 0 0 1 0 0 0 -1 0 0 0 1 4-4ring8.dat
1 14 0 0 0 9 0 0 0 -4.5 0 0 0 9 4-4cylo.dat
Let's delete the original data and we see that there arre gaps now:
Now we need to close those gaps. The back side pocket is pretty deep in the original part, but it has no funtional purpose, so we can flatten it.
We can start adapting to the head.