LDView Simplified boxes


RE: Simplified boxes
#16
If you have lines like this:

Code:
1 14 0 -8 -110 -1 0 0 0 1 0 0 0 -1 b\a3023.DAT

with a "b\a" or "b\b" or "b\t" before the part name, then it is working. The file name should be prefixed with "boxed_" as well. Other than that, I have no idea. I don't know what might be the problem, or how to test or reproduce it. If anyone has any suggestions, that would be great.

I have attached the version of the file I get when I run the tool.


Attached Files
.ldr   boxed_m6459.ldr (Size: 4.2 KB / Downloads: 1)
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Simplified boxes - by Michael Horvath - 2021-06-12, 3:09
RE: Simplified boxes - by Travis Cobbs - 2021-06-12, 4:51
RE: Simplified boxes - by Travis Cobbs - 2021-06-12, 4:54
RE: Simplified boxes - by Travis Cobbs - 2021-06-12, 4:55
RE: Simplified boxes - by Travis Cobbs - 2021-06-12, 5:23
RE: Simplified boxes - by Travis Cobbs - 2021-06-12, 5:34
RE: Simplified boxes - by Michael Horvath - 2021-06-12, 20:29
RE: Simplified boxes - by Michael Horvath - 2021-06-12, 20:29
RE: Simplified boxes - by Travis Cobbs - 2021-06-12, 20:40
RE: Simplified boxes - by Michael Horvath - 2021-06-12, 23:58
RE: Simplified boxes - by Travis Cobbs - 2021-06-13, 0:52
RE: Simplified boxes - by Michael Horvath - 2021-06-13, 1:23
RE: Simplified boxes - by Travis Cobbs - 2021-06-13, 2:42
RE: Simplified boxes - by Michael Horvath - 2021-06-13, 15:43
RE: Simplified boxes - by Travis Cobbs - 2021-06-14, 5:22
RE: Simplified boxes - by Michael Horvath - 2021-06-14, 21:58
RE: Simplified boxes - by Travis Cobbs - 2021-06-14, 22:09
RE: Simplified boxes - by Michael Horvath - 2021-06-15, 5:09

Forum Jump:


Users browsing this thread: 1 Guest(s)